1. DL manuals
  2. Nady Systems
  3. Microphone system
  4. ENCORE 200
  5. Owner's Manual

Nady Systems ENCORE 200 Owner's Manual

Other manuals for ENCORE 200: Owner's Manual

Summary of ENCORE 200

  • Page 1

    Nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference receiv...

  • Page 2

    (u.S.) should your nady encore 200 wireless microphone system require service, please contact the nady service department via telephone at (510) 652-2411 or e-mail to service@nady.Com for a return authorization (r/a) number and a service quote (if out of warranty). Make sure the r/a number is clearl...

  • Page 3

    Contents ....................................................................................................... 3 introduction ................................................................................................ 3 using this manual ..........................................................

  • Page 4

    4 9 f e a t u r e s • customized specially for use wih bass guitars — playing your wireless bass never sounded so good! • enhanced headroom™ for maximum possible clarity and distortion-free audio, even with high output active pickups • bass boost™ adjust for tuning in exactly the right bass punch an...

  • Page 5

    1. Rackmounting the receiver there are 2 options available for rackmounting the encore 200 receiver: singly or side-by-side with another encore series receiver. A. Single mounting: remove the receiver side mount clip (1) from each side of the receiver (as shown) and slide in the optional erm-12 rack...

  • Page 6

    5. Bass boost control ordinary wireless systems all sound somewhat thinner (with less bass) than hardwired. This is due to (1) natural side effects of the noise reduction circuitry employed, and (2) lack of the high-frequency roll-off normally caused by longer hardwired cable runs. Adjust the bass b...