Nady Systems UHF-4 Owner's Manual

Other manuals for UHF-4: Owner's Manual, Owner's manual
Manual is about: Single Channel UHF DigiTRU Diversity Wireless System

Summary of UHF-4

  • Page 1

    Nady systems, inc. 6701 shellmound street • emeryville, ca 94608 tel: 510.652.2411 • fax: 510.652.5075 • www.Nady.Com service information (u.S.) if you are experiencing operation problem with your system, check out the support page on the nady website: www.Nady.Com for help and for contacting the na...

  • Page 2

    Group 1 channel 2: 802.30 mhz channel 5: 794.90mhz 15 specifications overall system specifications frequency response .............................................................................................20hz-20khz, -3db dynamic range .............................................................

  • Page 3

    14 • the receiver antennas should be kept away from any metal surface. • if the volume control of the receiver is set too high, it may over-drive the input of the mixer, caus- ing distortion. Conversely, if the output is set too low, the overall signal to noise ratio of the system may be reduced. Ad...

  • Page 4

    4 uhf-24 receiver rack-mounting the receiver there are two options available for rackmounting the uhf-24 dual channel receiver: single or side-by-side with another uhf-24 receiver. A. Single mounting: remove the side mount clips (1) from each side of the receiver and slide in the optional erm-3 rack...

  • Page 5

    12 receiver volume controls adjust the volume controls work only for the 1⁄4” sum output. Turn volume controls on the uhf-24 receiver clockwise to near full gain. Adjust volume up or down so that no audio distortion is present when amplifier or mixer is set at their usual levels. At full gain, the sy...

  • Page 6

    Internal tone squelch defeat feature. Contact your nady dealer or nady systems customer service for details.) note: • even though your system has tone squelch™, it’s always best to keep the volume controls of unused channels, (with corresponding transmitter off) turned off in the amplifier or the mix...

  • Page 7

    7 uh-4 handheld transmitter transmitters set up the uh-4 transmitter requires a single 9v battery to operate. To open the battery compartment, unscrew the battery cover (16) with a counter-clockwise turn and remove the cover, exposing the battery holder (17). Insert a fresh 9v battery according to t...

  • Page 8

    9 ub-4 bodypack transmitter the ub-4 is equipped with two input selector switches (27) located under the cover on the circuit board for selecting the type of audio input you will be supplying to the transmitter. Select from the choice of three positions: instrument (for guitar, bass, etc.)/ headworn...