Owner's manual uhf-4 single channel uhf digitru diversity™ wireless system uhf4_man 2/15/05, 4:09 pm 1.
Contents ...........................................................................................2 introduction .................................................................................... 2 using this manual............................................................................ 2 sy...
3 uhf-4 receiver • unprecedented value in a full-featured single-channel uhf wireless mic system — with interference-free operation in any application or locale on select uhf frequencies within separate bands 902-928 and 944-952 mhz • half-rack receiver design with folding front panel dual antennas ...
4 1. Rackmounting the receiver there are 2 options available for rackmounting the uhf-4 receiver: singly or side-by- side with another uhf-4 series receiver. A. Single mounting: remove the receiver side mount clip (1) from each side of the receiver (as shown) and slide in the optional erm-3 rack ear...
5 5. Connecting the audio output the uhf-4 receiver provides both a fixed mic level balanced mic audio output xlr (7) and an adjustable line level aux audio output 1/4" jack (10). (note: as when making any connection, make sure the amplifier or mixing board volume is at the minimum level before plug...
6 12 11 15 13 14 15 10 9 8 6 5 7 2 1 2 4 3 1 4 uhf4_man 2/15/05, 4:10 pm 6.
7 1. Unscrew the battery compartment cover (16) and remove, exposing the battery holder (17 ). Insert a fresh 9v alkaline battery (18), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. Fresh alkaline batteries can ...
8 1. Snap open the battery door (22) and insert a fresh 9v alkaline battery into the battery compartment (23) , observing the correct polarity. Fresh alkaline batteries can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that the battery be replaced after 6-...
9 6. Instrument use secure the connection from the gt cable (30) by turning the slip ring on the plug into the transmitter clockwise to thread it on the jack. To unplug, reverse the process. Plug the 1/4” phone plug into the instrument. When ready to play, slide the audio mute switch (26) to “on” po...
10 30 31 32 opening battery compartment 22 23 24 26 25 28 27 29 instrument g h l g hl g h l g hl g h l g hl headworn lavalier input selector switches uhf4_man 2/15/05, 4:10 pm 10
11 uhf-4 overall system performance frequency response 30 hz - 18 khz, +/– 3 db dynamic range 120 db total harmonic distortion rf carrier frequency range uhf, choice of single frequencies within separate bands 902-928 and 944-952 mhz frequency stability +/- 0.005%, crystal controlled modulation fm (...
Nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference receiv...
