Nady Systems UWS-1K Series Owner's Manual - page 4
4
SYSTEM OPERATION
3. UWS-1K Receiver Buttons Function
Each time the Set Button (19) is pressed the LCD Menu (10) display will cycle through the set up
menus in this order: MAIN MENU->CHANNEL->GROUP->SQL->MAIN MENU and then repeat.
The selected function will flash for 20 seconds before returning to the MAIN MENU. To exit from any
setting menus, press Transfer Button (18) once.
When pressing the Transfer Button (18) once while MAIN MENU is displayed, the Power LED (9)
will flash quickly. This LED indicates IR transmission is in progress. Press Transfer Button (18)
again to stop or it will expire in 20 seconds automatically.
The UP-DOWN Rocker button (20) works only while setting the menu. At Power OFF the UWS-1K
receiver will store the last settings entered and re-display them at Power ON. It can be repro-
grammed to any new group/channel, and SQL level. The default factory setting is Group 13, Chan-
nel 01, and SQL 01.
4. Selecting the UWS-1K Receiver Group, Channel,
& SQL Setting
See Section 26 below (RF Interference and Finding Open Channels) also for help in finding desired
channel(s) of operation in setting up your system(s).
Choose the UWS-1K operating frequency by selecting one of 25 Groups and one of 40 Channels
in each group that are determined to be desirable open channels as per the procedure outlined
in Section 26. The first two large digits on the left are the GROUP (11) and the second two large
digits on the right are for the CHANNEL (11). Press the Set Button (19) once to enter the CHAN-
NEL (11) set up mode and then press the UP-DOWN Rocker button (20) once for single stepping
through the channels or hold continuously for faster channel selection. Select one of 40 channels
available from the CHANNEL (11) menu and advance to GROUP (11) set up mode by pressing Set
Button (19) or press Transfer Button (18) to exit.
Press the Set Button (19) again to enter the GROUP (11) set up mode and then press the UP-
DOWN Rocker button (20) once for single stepping through the groups or hold continuously for
faster group selection. Select one out of 25 groups from the GROUP (11) menu and advance to
SQL (14) set up mode by pressing Set Button (19) or press Transfer Button (18) to exit.
Press the Set Button (19) once to enter the SQL (14) set up mode and then press the UP-DOWN
Rocker button (20) once for single stepping through the SQL (RF muting/squelching) levels or
hold continuously for faster SQL level selection. Select one out of 50 levels from the SQL menu and
advance to Exit set up mode by pressing Set Button (19) or press Transfer (18) to exit.
Press Set Button (19) once to exit or press Set (19) twice to restart selection of a different chan-
nel, group, or SQL level. When the exit mode is reached, the new group/channel/SQL selected are
programmed.
5. UH/UB-1K Transmitters Buttons Function
Press the Power Button (23/32) for more than 2 seconds to power up the transmitter (please also
see section 14 & 18 below). It will now be in standby (audio input muted) mode. Press the Power
Button (23/32) again briefly to unmute or to mute the audio.