NAG SNR-MPX-16E1-SFP User Manual - Snr-Mpx-16E1-Sfp
SNR-MPX-16E1-SFP
16E1 + 1Ethernet Fiber Optical Multiplexer
6/5/2009
Shop.Nag.Ru
Page 13 of 16
CHAPTER 4. OPERATION
4.1 Equipment installation
After unpacking and before installation, make sure checking the following:
•
Make sure the package is well. If the package is damaged, contact service office
quickly for solution.
•
Check the package according to the product list, if find equipment severe damaged
or lack of some components, please contact installation worker or service office of
us.
•
Check whether the equipment type meets with the type you ordered.
•
Check whether the component is in integrity.
•
Check the power supply type.
4.2 Quick installation
•
Fasten the Equipment in 19 inch rack with the screws in the equipment package.
•
Use reliable ground connection at GND point of the equipment
•
Use power tab to connect power according to the manual, don’t exchange the
polarities.
•
Create user equipment connecting wire according to your demand (2M, V.35 and 10
Base-T), then connected, don’t exchange receive and transfer wires.
•
Connect SFP module to the SFP lot, make sure the optical fiber head is clean and
connection well. (fiber bending radius
≥
50 mm)
•
Use multimeter to test power polarity and voltage, make sure it matches with
equipment requirement.
•
After complete installation and make sure it’s ok, power on the switch. Check
indicator light meet with practice situation (see related part of manual).
•
A clean, steady environment and firm installation should be provided for desktop or