Nagra NAGRA-V Operating Instructions And Reference Manual - page 14
Chapter I
11
May 2002
RIGHT SIDE PANEL
Banana Output Connectors (1)
This is the telephone output connection. It is a mono output fitted with a transformer with
output impedance of 600 from 300 Hz to 5 kHz, and is used for connection to a standard
switched telephone line. The output level of this connection can be selected in the TEL
LEVEL position of the menu mode to be either 1.55V or 4.4V. When in operation, the return
feed from the telephone can be heard in the headphones or on the internal loudspeaker if
selected.
Line Output Connectors (2)
These two 3 pole XLR female connectors are the standard analog audio
transformer-less outputs. The level of which can be controlled by the Line Output
potentiometer on the front panel (providing it has been previously selected). The
nominal output level on these connectors is 1.55V for 0 dB on the meter.
Pin #
Connection
1
Ground
2
Audio signal High
3
Audio signal Low
WARNING:
Be sure not to connect these outputs to a mixer supplying 48V phantom as this will damage
the outputs.
AES Output Connector (3)
The 3 pole male XLR AES output connector is a digital output corresponding to the
format of the AES bus used throughout the professional audio industry.
The
resolution is of 16 bits or 24 bits depending of the output settings. This connection
allows direct connection to any other digital equipment equipped with an AES
interface
1
2
3
4
5
6
7
8