Nakamichi CD-45z Owner's Manual - page 11
Nakamichi Mobile Sound System
English
11
Power button/
Source Selector button
Sound Tuning
Mode selector/
Loudness button
Clock button
Track/ Tune
Volume
Source
P.Scan
Mute
Select
D
PS
D
PS
Mono
Clock
A.Mem.
FM/AM
Power
Off
Loud.
Tuner Mode button
Beep sound
Normally, when a button on the unit or a button on
the remote control is pressed, a short beep is heard
which serves as a confirmation that the command
was received. To disable this feature, proceed as
follows. While the unit is turned off, keep the Mute
button depressed and press the Power button to
turn the unit on. Repeat this procedure when you
wish to re-enable the beep sound.
* The beep sound is output from the front speakers. If
only rear speakers are connected, no beep will be heard.
Reset button
In normal operation, this button is not needed. Only
if the controls of the unit for any reason do not
seem to operate correctly, press this button.
Detachable front panel
When the Front Panel Release button is pressed,
the front panel can be separated from the main
unit for safekeeping. To reattach the front panel,
press it against the main unit until you hear a click.
* Do not touch the connector pads on the front panel and
the main unit, to prevent contact problems. If a contact
pads has become dirty, wipe it with a dry, clean cloth.
Changing the playback mode indication
Use the following procedure if you want to change
the playback mode indication when equipment was
connected to the "AUX IN" or the "CDC IN" jacks*.
1. Use the Source Selector button to select AUX
mode (or CD changer mode).
2. Pressing the Sound Tuning Mode selector
switches the display in the following order:
"
BAS", "MID", "TRE", "BAL", "FAD", "AUX" (or
"
CDC"), "VOL", "BAS" ...
3. Turning the Volume controller clockwise while
"
AUX" (or "CDC") is flashing calls the indica-
tion "
CD", "MD", "TV", "AUX", "CD" ... (or
"
AUX", "CD", "MD", "TV", "CDC", "AUX" ... in
CD changer mode) onto the display. This al-
lows you to match the display to any kind of
connected equipment.
- When the mode indication was changed as de-
scribed above, the selected indication will be
shown again the next time the AUX mode (or
CD changer mode) is activated.
* Connecting equipment is only possible when the CD
changer is not connected. Note that the "CDC IN" jack
name may vary depending on the sales region where
purchased
Volume
controller
(
:up /
:down)