Nakamichi CD-45z Owner's Manual - page 17
Nakamichi Mobile Sound System
English
17
Track/ Tune
Volume
Source
P.Scan
Mute
Select
D
PS
D
PS
Mono
Clock
A.Mem.
FM/AM
Power
Off
Loud.
Auto memory
1. Select the frequency band (FM1, FM2, FM3,
AM1, AM2) with the Band Selector button.
2. Keep the Auto Memory button depressed for
about 2 seconds or more. The unit then auto-
matically assigns six of the strongest stations
to the Preset Station buttons 1 - 6.
- If fewer than six stations were found on the first
pass, the unit switches to the higher-sensitivity
DX mode, and the auto memory function con-
tinues.
- If fewer than six stations were found on the sec-
ond pass, the stations found so far are assigned
to the preset station buttons, and the first pro-
grammed station is received.
- If no stations could be programmed, the unit re-
mains tuned to the frequency of the station that
was received when the auto memory button was
pressed.
- Since six stations can be memorized for each
tuner band, the total memory capacity is 30 sta-
tions.
Preset scan
1. Select the frequency band (FM1, FM2, FM3,
AM1, AM2) with the Band Selector button.
2. When the Preset Scan button is pressed, all
stored broadcast stations in the selected fre-
quency band (FM or AM) are tuned in consecu-
tively for 5 seconds each.
3. When you have found a station you want to lis-
ten to, press the Preset Scan button once more.
The preset scan stops and the unit stays tuned
to that station.
Stereo/mono switching
If excessive noise is heard during reception of an
FM station, keep the Mono button depressed for
about 1 second or more to switch to monaural
mode. The indication "ST" disappears from the
display and the sound will be in mono, but noise
will be reduced.
- To cancel the monaural mode, press the Mono
button again for about 1 second or more. The
monaural mode is also canceled when you tune
to a different frequency or turn the unit off.
Source Selector button
Preset Scan button/
Auto Memory button
Auto Seek button/
Manual Tuning button
These buttons switch
preset stations
(continuously if pressed for
1 second or more)
Band Selector button/
Mono button