Nakanishi SHEENUS neo Operation Manual - page 10
24
6. OPERATING PROCEDURES
(1)
Turn ON the Main Power Switch
④ and make sure the Display ⑧ appears.
(2)
Select UNCLAMP / CLAMP mode using the UNCLAMP / CLAMP Switch
⑤ .
The UNCLAMP mode (
) or CLAMP mode (
) LED will illuminate green.
CAUTION
・ Use CLAMP mode (
) for the Tip Holders
⑮.
・ Use CLAMP mode (
) for the M4 Screw Joint Adaptor
⑰.
・ Use UNCLAMP mode (
) for One-Piece Tools
⑯ (for M6).
・ The screw size of the One-Piece Tools ⑯ is M6 x 0.9. Do not use different sized screws.
・ Never remove or attach the plug of Handpiece ② or the plug of Foot Switch while depressing
the Foot Switch
③. Failure to follow this warning may result in an error code or damage to the
Control Unit
①.
・ Please use a maximum of 8W of electric power when in continuous operation.
・ Do not use Tip Holders ⑮ with the Control Unit ① set in UNCLAMP mode (
). Use CLAMP
mode (
) for clamped tools.
・ Using tools at too high a power setting can cause the tools and Tip Holders ⑮ to get extremely
hot and damage the Handpiece
② and Control Unit ①, causing tools to burn and cause injuries.
(3)
Set the Power Control Knob
⑨ to a minimum setting.
(4)
Press the ON / OFF Switch
⑥. ON LED lamp will light up GREEN.
* When operating by the Foot Switch
③, the ON LED lamp will light up by pressing the Foot Switch ③.
(5)
The display screen "WATT" "POWER" can be changed by pressing the DISPLAY Switch
⑦.
(6)
Adjust output power to the optimum level for the work by turning the Power Control Knob
⑨ clockwise.
(7)
Press the ON / OFF Switch
⑥ again to stop. The OFF LED lamp will light up green and stop the operation.
* When operating by the Foot Switch
③, releasing the Foot Switch ③ will stop the operation.
(8)
Make sure to turn OFF the Main Power Switch
④ after use.
Fig. 11
7. PROTECTION CIRCUIT
⑧ DISPLAY
⑦ DISPLAY Switch
⑨ Power Control Knob
⑤ UNCLAMP / CLAMP Switch
⑥ ON / OFF Switch
④ Main Power Switch
(1)
Protection System
The RESET LED lamp (RED) will illuminate and the operation will stop automatically in the following
situations.
・Too much pressure on the tool.
・The tool is not clamped properly.
・The tool is likely broke or the brazing on the tool is loose.
・The internal temperature in the Control Unit ① is too high.