Nanoxia Deep Silence 3 User Manual - page 5
EN
Next, mount the CPU cooler - for bulky coolers, the attachment of the EPS extension after
installation can be difficult. Place the motherboard carefully into the case and thread while the
EPS extension through the opening provided at the top of motherboard tray.
Then screw the motherboard to the motherboard standoffs. After installing the power supply,
you can connect the EPS extension at the back of the motherboard tray with the EPS connector
of the power supply.
2. Installation of external drives
You can install up to three external drives in the Deep Silence 3. An adapter frame for
mounting a 3.5 inch drive is included.
2.1 Optical drives
To install the optical drives, please remove both side panels. The installation of optical drives is
tool-free.
Remove the 5.25 inch cover by pulling the lateral tilting lever cautiously towards you and take
out the cover.
Then loosen the lock on both sides by dragging the
black slider backwards (1).
Next slide the drive into the desired position.
Lock the holder by pushing the slider back to its original
position (2).
Please note that the two lower shafts are equipped with steel panels, which you have to
remove when you want to use the lower drive bays. To do this, move the steel panels gently
back and forth until you can remove them.
2.2 Utilizing the external 3.5 inch bay
If you for example desire to place a 3.5 inch card
reader, you can use the internal adapter for this
purpose.
Before you take out the internal adapter, please
remove the 3.5 inch steel cover as shown on the
picture.
1
2
04