- DL manuals
- NAPCO
- Touch Panel
- F-TPBR
- Manual
NAPCO F-TPBR Manual
Summary of F-TPBR
Page 1
1 r using your napco freedom f-tpbr touchpad home security system © napco 2005 patented oi308 10/05 night disarm/ silence bypass stay f-tpbr_oi308.06_user_anc... Page 1 friday, october 28, 2005 15:14 composite.
Page 2
2 congratulations on your purchase of a new deadbolt-activated napco freedom security system. This revolutionary new concept in residential security makes using your system easier than ever before possible, because the system uses its computerized control panel to continually monitor the status of y...
Page 3: Table of Contents
3 t ab l e o f c o n t e n t s table of contents introduction............................................................... 2 testing the system ................................................... 2 f-tpbr touchpad indicators.................................. 4 f-tpbr touchpad controls ...............
Page 4: Ready
4 ready armed stay fire tbl • f - t p b r t o u c h p ad i n d i c at o r s the green ac light on indicates that ac power is present. The yellow trouble tbl lightwill light and the f-tpbr touchpad sounder will pulse to indicate that a system trouble is present. If zone(s) have been bypassed, tbl wil...
Page 5
5 f - t p b r t o u c h p ad c o n t r o l s f-ifob -the f-ifob is a uniquely coded digital key which must be used to disarm the system and silence the siren in case of alarm. To silence an alarm, simply insert into the f-ifob slot on the f-tpbr touch- pad and remove when alarm has silenced. Motion ...
Page 6
6 b y p as s i n g f au l t e d z o n e s if you are trying to arm with a faulted zone or zones, the green ready light will be blinking out the number of the faulted zones. If you cannot repair the zone(s), they may be temporarily removed from the system, or bypassed, using the fol- lowing procedure...
Page 7
7 ar m i n g w h e n s t ay i n g h o m e arming in the stay mode allows you to remain home with the perimeter protection active and the interior protection off, so that you may move freely about the premises. 1 check the f-tpbr touchpad indicators. The green ready light should be on-steady, indicat...
Page 8
8 arming in the night mode allows you to remain home with all perimeter and interior protection active--except for the f- tpbr touchpad pir. If the f-tpbr touchpad is located in the bedroom, you may move about the bedroom freely. 1 check the f-tpbr touchpad indicators. The green ready light should b...
Page 9
9 e m e r g e n c y b u t t o n s the emergency buttons, if programmed, are always active, whether the system is armed or disarmed. The emergency button must be held down for 3 seconds to activate the emergency alarm and transmit the signals to central station. Police emergency hold down the police ...
Page 10
10 d i s ar m i n g t h e s y s t e m disarming when home (armed night or stay): to disarm the system. Press the disarm/silence button on the f-tpbr touchpad. • this function is available only when armed in the night mode or stay mode. • if the system is armed in the away mode (interior fully protec...
Page 11
11 if an alarm occurs while you are at home: the touchpad sirens will sound and the red armed light will flash. Proceed with caution! If you suspect that an intruder may still be in the premises, leave immediately and call authorities from a neighbor's telephone. To silence the alarm, insert your f-...
Page 12
12 if a fire is detected, the siren will sound a distinct pulsating tone and the fire indicator on the f- tpbr touchpad will be flashing. If a fire alarm does occur: * note: this feature may not apply to your system. Consult your installer to determine if your system includes fire protection. 1 if a...
Page 13
13 f i r e p r o t e c t i o n preparing a fire escape plan even with the most advanced fire alarm system, adequate protection requires an escape plan. To prepare your plan, draw floor plans of your building. Show two exits - a front or back door and a window from each room. (make sure the window wo...
Page 14
14 your napco freedom security system is constantly monitoring its own components, as well as all critical services, such as ac power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble occurs, the f-tpbr touchpad will ...
Page 15
15 system trouble error codes tbl flashes / touchpad beeps ready flashes trouble condition action 6 none lost key mode this is a reminder that the system has been put into the lost key mode ([stay] & [away] pressed simultaneously). While in this mode, the system can only be disarmed with your f-ifob...
Page 16
16 the space below is for recording the descriptions of the zones in your system. • if the system has a faulted zone, count the number of ready light flashes and refer to the list below to see which zone is open and secure it (close the door or window, etc.). • if an alarm has occurred, count the nu...
Page 17
17 federal communications commission (fcc) part 68 statement this equipment complies with part 68 of the fcc rules. On the front cover of this equipment is a label that contains, among other information, the fcc registration number and ringer equivalence number (ren) for this equipment. If requested...
Page 18
18 warning! The limitations of this alarm system while this system is an advanced design security system, it does not offer guaranteed protection against burglary or fire or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variet...
Page 19
19 warning! The limitations of this alarm system (cont'd) • even if the system responds to the emergency as intended, however, occupants may have insufficient time to protect them- selves from the situation. In the case of a monitored alarm system, authorities may not respond appropriately. • this e...
Page 20
20 napco limited warranty napco security systems, inc. (napco) warrants its products to be free from manufacturing defects in materials and workmanship for thirty-six months following the date of manufacture. Napco will, within said period, at its option, repair or replace any product failing to ope...
Page 21
21 written, are either merged herein or are expressly cancelled. Napco neither assumes, nor authorizes any other person purporting to act on its behalf to modify, to change, or to assume for it, any other warranty or liability concerning its products. In no event shall napco be liable for an amount ...
Page 22
22 the following statement is required by the fcc radio and television interference this equipment has been tested and found to comply with the limits for a class-b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interf...
Page 23: Notes
23 notes f-tpbr_oi308.06_user_anc... Page 23 friday, october 28, 2005 15:14 composite.
Page 24
24 333 bayview avenue amityville, new york 11701 for sales and repairs, (800) 645-9445 for technical service, (800) 645-9440 publicly traded on nasdaq symbol: nssc r © napco 2005 f-tpbr_oi308.06_user_anc... Page 24 friday, october 28, 2005 15:14 composite.