Summary of GEMINI-P400
Page 1
1 using your gem-p400 security system ar med sta tu s h 1 2 3 4.
Page 2
2 this page left blank intentionally.
Page 3
3 congratulations on your purchase of an advanced gemini-p400 security system. Meticulously developed by a leading manufacturer of state-of-the-art security products, this system will provide you with unprecedented peace-of-mind & incorporates some of the most sophisticated features available today....
Page 4
4 introduction system information central station phone number: ________________________ central station account number: ______________________ for service call: ___________________________________ entry delay: _______________________________________ exit delay: _____________________________________...
Page 5
5 ar me d st a t u s h 1 2 3 4 keypad controls and indicators trouble light h will light and the keypad sounder will pulse to indicate that a system trouble is present. (see system troubles, page 11) status light will light when all zones are secure and system is ready to be armed. Armed light will ...
Page 6
6 arming your system when leaving 1 before arming your system, make sure the green status light is on. This indicates that all of your protective zones are secure. If any zones are open, the corresponding zone number will be lit. Secure these zones before proceeding. If any zones cannot be secured, ...
Page 7
7 protecting yourself while at home 1 before arming your system, make sure the green status light is on. This indicates that all of your protective zones are secure. If any zones are open, the corresponding zone number will be lit. Secure those zones before proceeding. 2 enter your user code and pre...
Page 8
8 emergency buttons 8 9 g the three sets of emergency buttons, if programmed, are always active whether the system is armed or disarmed. Discuss these buttons with your installer. The emergency signal will only be activated when the two respective buttons are pressed at the same time. Auxiliary alar...
Page 9
9 disarming your system when returning 1 enter your premises through the entry/exit door. The keypad will sound a steady tone to remind you to disarm the system before your entry delay time expires. 2 enter your user code and press d . The red armed light will go out, indicating that the system has ...
Page 10
10 special functions by pressing a followed by the the appropriate key, (do not press simultaneously) these special functions and features can be enabled: easy arm (when system is disarmed) the easy arm feature allows the system to be armed pressing a followed by 0 . This will allow the easy arming ...
Page 11
11 the gem-p400 is constantly monitoring its own components, as well as all critical services, such as ac power and the telephone line, to ensure that it is always ready to provide the protection for which it was designed. When a system trouble does occur, it will caution you by lighting the trouble...
Page 12
12 system troubles h keypad beeps or h flashes zone light on system trouble condition action 2 beeps 3 wireless receiver trouble a problem has been detected with the wireless receiver. Call installing company for service. 2 beeps 4 wireless receiver jam a problem has been detected with a wireless re...
Page 13
13 your installer has assigned a user 1 code which can be used to not only arm and disarm the system, but also to enter the user program mode, where you can program other user codes. The following explains how you will use this code to program or erase additional user codes. Entering the user progra...
Page 14
14 ambush code - in the event that you are forced by an intruder to disarm your system, this special code can be used to disarm the system, and simultaneously send a silent alarm to central station. If your system has the ambush feature enabled, the code assigned as the user 4 code will function as ...
Page 15
15 notes.
Page 16
16 napco limited warranty the following statement is required by the fcc . This equipment generates and uses radio-frequency energy and, if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. I...