Napoleon 1600C-1 Installation And Operating Instructions Manual

W415-0721 / 05.06.09

1

INSTALLER:  LEAVE THIS MANUAL WITH THE APPLIANCE.

CONSUMER:  RETAIN THIS MANUAL FOR FUTURE REFERENCE.

INSTALLATION AND 

OPERATING INSTRUCTIONS

1.11

Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 4Y8 Canada / 

103 Miller Drive, Crittenden, Kentucky, USA, 41030

Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • ask@napoleon.on.ca

SAFETY INFORMATION

!

WARNING

If the information in these instructions are not followed exactly, a 

fi

 re or explosion may result causing property damage, personal 

injury or death.

Please read entire manual before you install and use your heater.

This heater has not been tested with an unvented gas log set. To 

reduce risk of 

fi

 re or injury, do not install an unvented gas log set 

into the heater.

-  This heater can be very hot when burning.

-  Combustible materials such as 

fi

 rewood, wet clothing, etc. placed too 

close can catch 

fi

 re.

-  Children and pets must be kept from touching the heater when it is 

hot.

-  The chimney must be sound and free of cracks. Before installing 

this unit, contact the local building or 

fi

 re authority and follow their 

guidelines.

-  Operate only with the doors tightly closed.

-  Burn wood behind the log retainer directly on the 

fi

 rebricks.

-  Do not use an elevated grate or otherwise raise the 

fi

 re.

-  This heater is designed to burn natural wood only. Higher ef

fi

 ciencies 

and lower emissions generally result when burning air dried seasoned 

hardwoods, as compared to softwoods or to green or freshly cut 

hardwoods.

-  Do not start a 

fi

 re with chemicals or 

fl

 uids such as gasoline, engine 

oil, etc.

-  Do not burn treated wood, coal, charcoal, coloured paper, cardboard, 

solvents or garbage.

-  Do not let the heater become hot enough for any part to glow red.

- KEEP THE STOVE TOP TEMPERATURE BELOW 700°F (371°C). 

Attempts to achieve heat output rates that exceed design 

speci

fi

 cations can result in steel distortion and damage.

$10.00

CERTIFIED UNDER U.S.  ENVIRONMENTAL PROTECTION AGENCY (E.P.A.) JULY 1990 AND THE OREGON DEPARTMENT OF ENVIRONMENTAL QUALITY (D.E.Q.) 

PARTICULATE EMISSION STANDARDS BY E.E.M.C. THESE STOVES HAVE BEEN TESTED AND LISTED BY WARNOCK HERSEY LTD. TO STANDARDS : UL 1482 / ULC-S627.

MODEL 1600C-1 HAS BEEN TESTED AND LISTED FOR INSTALLATION IN MOBILE HOMES.

MODEL

1600C-1