Summary of EPA 1100

  • Page 1

    1 w415-0763 / b / 10.28.11 installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Never leave children or other at risk individuals alone with the appliance. Installation and operating instructions 1.27a wolf steel ltd., 24 napoleon rd., barrie, on, l4m 0...

  • Page 2: Table of Contents

    2 w415-0763 / b / 10.28.11 note: changes, other than editorial, are denoted by a vertical line in the margin. Table of contents 1.0 installation overview 3 2.0 introduction 4 2.1 dimensions 5 2.2 specifications 5 2.3 general instructions 6 2.4 general information 7 2.5 rating plate information 8 3.0...

  • Page 3: 1.0 Installation Overview

    3 w415-0763 / b / 10.28.11 1.0 installation overview blower, see “optional blower kit installation” section. Handle, see “door and handle installation” section. Draft, see “air control” section. Door, see “door removal / installation” section. Rating plate, see “rating plate information” section. 14...

  • Page 4: 2.0 Introduction

    4 w415-0763 / b / 10.28.11 2.0 introduction 3.17c ! Warning • this appliance is hot when operated and can cause severe burns if contacted. • any changes or alterations to this appliance or its controls can be dangerous and is prohibited. • do not operate appliance before reading and understanding op...

  • Page 5

    5 w415-0763 / b / 10.28.11 specifications ref. 1100 1150 1400 & 1450 1900 width a 25 1/2” 29 3/8” 25 1/2” 25 1/2” depth b 22 1/2” 23 3/16” 27” 31 1/2” flue center line to rear c 6 1/2” 6 3/4” 7 1/2” 7 1/2“ flue center line to side d 12 3/4” 14 11/16” 12 3/4” 12 3/4” height e 33 1/4” 36 1/2” 33 1/4” ...

  • Page 6: Warning

    6 w415-0763 / b / 10.28.11 2.3 general instructions 4.7 all wiring should be done by a qualified electrician and shall be in compliance with local codes. In the absence of local codes, use the current csa22.1 canadian electric code in canada or the current national electric code ansi/nfpa no. 70 in ...

  • Page 7: Warning

    7 w415-0763 / b / 10.28.11 your appliance has been specifi cally designed over many months of research to meet the 1990 u.S.A. Epa particu- late emission standards and have been extensively tested in canadian and american laboratories. This system is the most effi cient, simple and trouble free we k...

  • Page 8: Sample

    8 w415-0763 / b / 10.28.11 2.5 rating plate information for rating plate location, see “installation overview” section. This illustration is for reference only. Refer to the rating plate on the appliance for accurate information. 1400 series rating plate illustrated sample listed solid fuel burning ...

  • Page 9: Warning

    9 w415-0763 / b / 10.28.11 3.0 pre-installation preparation have an authorized dealer install the appliance. If you install the appliance yourself, have your dealer review your installation plans and/or installation. Draw out a detailed plan of the installation including dimensions and verify the di...

  • Page 10: Warning

    10 w415-0763 / b / 10.28.11 3.4 floor protection 3.5 outside air if possible connect the air intake at the pedestal’s back or bottom to outside air with a 4 inch (100mm) diameter fresh air kit available at your authorized dealer / distributor. Follow detailed instructions under “mobile home outside ...

  • Page 11: Warning

    11 w415-0763 / b / 10.28.11 rain cap remove to allow for transporation mobile home roof flashing radiation shield ceiling support trim collar appliance bolted to floor hearth pad outside air connection through wall or floor model 1100 is approved for installation in mobile homes in both canada and t...

  • Page 12: 4.0 Installation

    12 w415-0763 / b / 10.28.11 4.0 installation 68.3a ! Warning wear gloves and safety glasses for protection. Carefully follow the instructions for assembly of the pipe and other parts needed to install the appliance. Failure to do so may result in a fire, especially if combustibles are too close to t...

  • Page 13: Warning

    13 w415-0763 / b / 10.28.11 ! Warning never install a single wall slip section or smoke pipe in a chase structure. The higher temperature of this single wall pipe may radiate sufficient heat to combustible chase materials to cause fire. Do not connect this appliance to a chimney system serving anoth...

  • Page 14

    14 w415-0763 / b / 10.28.11 your chimney connector and chimney must have the same diameter as the appliance’s exhaust fl ue outlet. The appliance pipe must be made of aluminized or cold roll steel with a minimum 24 gauge thickness. It is strictly forbidden to use galvanized steel. A 6” diameter sing...

  • Page 15

    15 w415-0763 / b / 10.28.11 4.1.2 adding sections add chimney sections, according to the manufacturers installation instructions. The chimney must extend at least, 3 feet above its point of contact with the roof and at least 2 feet higher than any wall, roof, building or obstacle within 10 feet hori...

  • Page 16

    16 w415-0763 / b / 10.28.11 4.1.3 typical through the ceiling a. Move the stove into position with the fl ue centered, midpoint between two joists to prevent having to cut them. Use a plumb bob to line up the center. B. Cut and frame an opening in the ceiling to provide a 2” clearance between the ou...

  • Page 17

    17 w415-0763 / b / 10.28.11 4.1.4 typical through the wall if possible, design the installation so that the connector does not pass through a combustible wall. If during your installation you must pass through a combustible wall, check with your building inspector before you be- gin. Also check with...

  • Page 18

    18 w415-0763 / b / 10.28.11 4.1.5 typical existing masonry you can also install your appliance using your existing masonry chimney. To do so, follow the guidelines below. You may want to use a factory- built thimble, or construct your own brick thimble. If you are using a masonry chimney, it is impo...

  • Page 19: 5.0 Finishing

    19 w415-0763 / b / 10.28.11 5.0 finishing a. Pivot the door open and lift up to clear the bushings. Do not pivot the door any further than necessary. B. Carefully set the door aside and pull the pins out from the door bushings. Repeat in reverse order to install the door. Pins 5.1 door removal / ins...

  • Page 20: Warning

    20 w415-0763 / b / 10.28.11 insert the ornamental trivet into the space on the stove top. Trivet ensure that the pedestal surfaces are clean and dry; peel the protective backing from the trim adhesive. Insert one end of the brass trim into one of the slots located in the pedestal and pressing fi rml...

  • Page 21

    21 w415-0763 / b / 10.28.11 a j i a a a a a a a a a a a a a a a b b b b b b b b a a a a a a a a a a a a a a a a a a a a a c c d d g g h h e f e f i j d d 1100 / 1150 1400 / 1450 1900 j a a a a a a a a a a a a a a a a a a a a a b b b b g h e f a a c c b b d d brick retainers 9” x 2” x 19 5/8” (fibre ...

  • Page 22

    22 w415-0763 / b / 10.28.11 5.6 1150 features to hang the lifter: remove the screw, as illustrated, from the preferred side of the stove rear. Secure the lid lifter hook, as illustrated, facing out to the side, or bend it towards the back. Lid lifter hook lid lifter handle firebox cast top optional ...

  • Page 23: Warning

    23 w415-0763 / b / 10.28.11 provisions have been made on the stove to install an optional blower kit (ep62-1) that comes complete with a variable speed switch to turn the blower on and off, as well as adjusting the blower speed. An optional thermostatic sensor control kit, ep36, to thermally activat...

  • Page 24: 7.0 Operation

    24 w415-0763 / b / 10.28.11 7.0 operation your napoleon epa listed product is a hi-tech appliance, designed with the most advanced technology. The appliance is extremely airtight. It has an exclusive direct outside air supply (optional kit), a feature designed to prevent spillage, and to help keep y...

  • Page 25

    25 w415-0763 / b / 10.28.11 you can now add larger pieces of wood and operate the appliance normally. Once the appliance is entirely hot, it will burn very effi ciently with little smoke from the chimney. There will be a bed of orange coals in the fi rebox and secondary fl ames fl ickering just belo...

  • Page 26

    26 w415-0763 / b / 10.28.11 7.3 lighting a fire 7.3.1 flash fire 7.3.2 extended fire 7.4 smoking 82.1 load your larger pieces of wood compactly, packed close enough to prevent the fl ames from penetrating it completely. After approximately 30 minutes, depending on the size of the load, close the dra...

  • Page 27: 8.0 Maintenance

    27 w415-0763 / b / 10.28.11 8.0 maintenance 8.1 ash removal procedures note: 1150 ash pans are not equipped with a cover or rear folding handle. Ash pan not available for model 1450. Allow the ashes in your fi rebox to accumulate to a depth of two or three inches; they tend to burn them- selves up. ...

  • Page 28

    28 w415-0763 / b / 10.28.11 since these models have no ash pan, shovel some ashes out through the door into a metal container with a tight fi tting lid. Keep the closed container on a noncombustible fl oor or ground, well away from all combustible materials. The ashes should be retained in the close...

  • Page 29: Warning

    29 w415-0763 / b / 10.28.11 ! Warning do not use substitute materials. Glass may be hot, do not touch glass until cooled. Care must be taken when removing and disposing of any broken door glass or damaged components. Be sure to vacuum up any broken glass from inside the appliance before operation. D...

  • Page 30: Warning

    30 w415-0763 / b / 10.28.11 8.7 gasket replacement if the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fi re will clean the glass. The most common reasons for dirty glass include: not using suffi cient fuel to get the appliance thoroughly hot, using ...

  • Page 31

    31 w415-0763 / b / 10.28.11 8.10 wood 87.1b when loading the appliance, ensure that the upper fi bre baffl es are not forced out of position. For maximum effi ciency, when the appliance is thoroughly hot, load it fully to the top of the door opening and burn at a medium low setting. The whiteness of...

  • Page 32: 9.0 Replacements

    32 w415-0763 / b / 10.28.11 9.0 replacements contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normally all parts can be ordered through your authorized dealer / distributor. For warranty replacement parts, a photocopy of the original invoice will ...

  • Page 33

    33 w415-0763 / b / 10.28.11 ** for available porcelain colours, add these letters to the base part number. Colour finish green - f brown - n black - k almond - s wrought iron - wi accessories ref # 1100 1150 1400 1450 1900 description 38 h222-g h222-g h222-g n/a h222-g door - gold plated 38 h222 h22...

  • Page 34

    34 w415-0763 / b / 10.28.11 27 20 45 30 32 33 34 40 38 16 25 39 35 29 28 13 12 15 24 26 17 36.

  • Page 35: 10.0 Troubleshooting

    35 w415-0763 / b / 10.28.11 10.0 troubleshooting 42.14a ! Warning turn off the electrical power before servicing the appliance. Appliance may be hot, do not service until appliance has cooled. Do not use abrasive cleaners. When checking connections, installing jumper wires (for test purposes only) o...

  • Page 36: 11.0 Warranty

    36 w415-0763 / b / 10.28.11 11.0 warranty napoleon® warrants its products against manufacturing defects to the original purchaser only. Registering your warranty is not necessary. Simply provide your proof of purchase along with the model and serial number to make a warranty claim. Provided that the...

  • Page 37: 12.0 Service

    37 w415-0763 / b / 10.28.11 43.1 12.0 service history.

  • Page 38: 13.0 Notes

    38 w415-0763 / b / 10.28.11 13.0 notes 44.1.

  • Page 39

    39 w415-0763 / b / 10.28.11 44.1.

  • Page 40

    40 w415-0763 / b / 10.28.11 44.1.