Installation and user instructions ya ht repeater c nasa marine ltd. Boulton road stevenage herts sg1 4qg england (01438) 354033 marine instruments designed and manufactured in england rohs 2002/95/ec.
Nasa yacht repeater table of contents 1 page 2 2 3 4 5 6 introduction installing the repeater questions and answers connecting the nmea inputs remote control test facility.
Fig 1b fig 1c fig 1a nasa marine yacht repeater introduction. The nasa marine yacht repeater displays essential navigation information from a range of nmea-0183 enabled devices. The large lcd display is easy to read at a distance and over a wide viewing angle. For night viewing the characters glow r...
Connect the display cable and the power cable to the data control box as shown in fig-2. Connecting the nmea inputs . The data control box has six nmea-0183 inputs. Four are single wire inputs which are referenced to ground (supply negative). Two are two wire inputs and have separate reference input...
Fig 3 when power is turned on the unit will first display information from input 1. Subsequent presses of the ch+ key will step through all the available data on that input channel then move to the next input channel. The remote control the remote control is powered by three aaa batteries. These can...
The remote is an infra red device and must be directed at the display when in use. Use the z + or z keys to increase or decrease the backlight intensity and use the ch + or ch keys to cycle up or down through the data fields. The red led on the remote will flash to confirm each key press. Pressing z...
Questions and answers. Q the display is blank and there is no red light on the data control box. A check you have a 12 vote supply with correct polarity. (positive to the centre pin of the power plug.) check the fuse (one amp.) q the red light glows on the data control box but the display is totally...
Notes: 7.
Declaration of conformity nasa marine ltd declare this product is in compliance with the essential requirements of r&tte directive 1995/5/ec. The original declaration of conformity certificate can be requested at info@nasamarine.Com this product is intended for use only on non solas vessels importan...
