NASA YACHT REPEATER Installation And User Instructions Manual - The Remote Control
FIG 3
When power is turned on the unit will first display information from input 1.
Subsequent presses of the CH+ key will step through all the available data on
that input channel then move to the next input channel.
THE REMOTE CONTROL
The remote control is powered by three AAA batteries. These can be zinc carbon,
alkaline, nickel metal hydride or nicad, though different batteries should not be
mixed.
To install the batteries, first carefully unscrew the four screws and remove the
back cover. Fit the batteries with the polarity as indicated on the battery holder
and replace the back cover. When replacing the back cover ensure that the "O"
ring seal is in place (With its overlap at the bottom.) and the four screws are fitted
with sealing rings and properly tightened. To prevent battery deterioration or
leakage it is recommended that the batteries are replaced at intervals no greater
than two years.
4