National Instruments NI TSM-1012 User manual - page 5
Installing the Touch Panel Driver on Windows
Take the following steps to download and install the touch panel driver after the NI TSM-101x
monitor is connected to a computer.
1.
Go to
http://www.salt.com.tw/en/service-support/downloads/software
.
2.
Click the button to confirm the license agreement.
3.
Select PenMount 6000 USB or PenMount 6000 RS-232 from the Controller pull-down
menu.
4.
Select Windows Desktop from the Operating System pull-down menu.
5.
Click the Search button.
6.
Click the link in the Driver Title column to download the installer package.
7.
Double-click Setup to make the welcome screen appear.
8.
Click Next.
9.
Click I Agree to accept the license agreement.
10. The Choose Install Location screen appears. Browse to a Destination Folder and click
Install.
11. When the installation is complete, click Finish.
Changing Touch Screen Modality on Windows
Take the following steps to change the touch screen modality from USB to RS-232 or vice
versa.
1.
Uninstall the PenMount 6000 touch screen driver.
2.
Remove the USB or RS-232 cable.
3.
Connect the monitor with the new cable.
4.
Download and install the correct PenMount 6000 driver.
Calibrating the Touch Screen on Windows
Take the following steps to calibrate the motion of the touch screen cursor with a touch screen
pen or finger.
1.
Ensure the monitor is properly connected through an RS-232 or USB cable.
2.
Ensure the touch screen driver is properly installed.
3.
Click the PenMount icon in the bottom left corner of the screen, as shown the following
figure, and select Control Panel.
Figure 2. The PenMount Icon
4.
The Control Panel dialog box appears. Double-click the PenMount 6000 icon on the
Device tab.
5.
The calibration screen appears. Select the Standard Calibration button.
NI TSM-101x User Manual
| © National Instruments | 5