National Instruments PXI EXPRESS PXIe-1095 User Manual - page 36
3-2
|
ni.com
Chapter 3
Maintenance
Exterior Cleaning
Clean the exterior surfaces of the chassis with a dry lint-free cloth or a soft-bristle brush. If any
dirt remains, wipe with a cloth moistened in a mild soap solution. Remove any soap residue by
wiping with a cloth moistened with clear water. Do not use abrasive compounds on any part of
the chassis.
Cautions
Avoid getting moisture inside the chassis during exterior cleaning,
especially through the top vents. Use just enough moisture to dampen the cloth.
Do
not
wash the front- or rear-panel connectors or switches. Cover these components
while cleaning the chassis.
Do
not
use harsh chemical cleaning agents; they may damage the chassis. Avoid
chemicals that contain benzene, toluene, xylene, acetone, or similar solvents.
Replacing the Power Supply
This section describes how to remove, configure, and install the AC power supply in the
PXIe-1095 chassis.
Caution
Disconnect the power cable and wait 30 seconds prior to removing the
power supply.
Before connecting the power supply to a power source, read this section and the
Read Me First:
Safety and Electromagnetic Compatibility
document included with the kit.