National Semiconductor LM32 User Manual - page 15
© Copyright 2004 National Semiconductor Corporation
14
www.national.com
3.1.3 LM41 Evaluation Board Connections Only
Connector
Label
Pin
Number
Description
J1 N/A
USB Cable Input. Connect the USB cable to this jack
after the SensorEval software has been loaded on the
PC.
1,2
NC On the evaluation board this is jumpered to ground.
3,4
GND On the evaluation board this is jumpered to ground.
5,6
3.3_SBY This is the +3.3V voltage supplied by the on-
board voltage regulator.
7,8
SWD This is the Single wire interface signal created by
the on-board microcontroller.
9,10
ADD This is the address select signal created by the on-
board microcontroller.
11,12
VCCP_IN This is the +1.2V voltage monitoring input to
the LM41. On the evaluation board this input is jumpered
to a +1.1V (typical) source.
J2
Output header
provides user with
signals for test
purposes only.
Do not apply any
external power or
signals to any of
the pins on these
headers!
13,14
+2.5VIN This is the +2.5V voltage monitoring input to the
LM41. On the evaluation board this input is jumpered to a
+1.1V (typical) source.
1,2
NC On the evaluation board this is jumpered to ground.
3,4
NC On the evaluation board this is jumpered to +3.3V.
5,6
+12VIN This is the +12V voltage monitoring input to the
LM41. On the evaluation board this is jumpered to +3.3V
for test purposes.
7,8
+5VIN This is the +5V voltage monitoring input to the
LM41. On the evaluation board this input is jumpered to
+3.3V. Note: J6 must also have a jumper installed
9,10 NC
11,12
D1+ This is the anode of the second remote diode input to
the LM41. A jumper connects to the base-collector
(anode) of Q2, a MMBT3904 transistor.
J3
Output header
provides user with
signals for test
purposes only.
Do not apply any
external power or
signals to any of
the pins on these
headers!
13,14
D1- This is the cathode of the second remote diode input
to the LM41. A jumper connects to the emitter (cathode)
of Q1, a MMBT3904 transistor.
J4, J5
These Headers are not used for evaluation board
purposes. They are not stuffed or used.
J6 1,2
Jumper these pins so that the +3.3V can be connected to
the +5VIN input to the LM41.
15 of 22