National Vacuum Equipment WPT 480/P Owner's Manual And Operating Instructions - page 26
of
52
26
| WPT Series
www.natvac.com | 800.253.5500
coolant.
6. Remove front oil line and shaft key.
7. Remove front bearing cover and coolant line.
8. Use a block or wood or heavy cardboard to
cushion the rotor.
9. Place a mark on the front endplate and on the front
of the housing for identification purposes.
Support the front end of the rotor and remove the
endplate bolts.
Lower the rotor to the bottom of the housing.