Native Watercraft Ultimate FX 12 Owner's Manual - page 11
of
16
11
Reinstalling the seat and the seat base is a
quick and easy process.
To begin locate the approximate seat position in the
boat.
Insert one side of the seat base into the boat and
under the rail opposite of the side that you are
standing.
Push down on the side that is not yet inserted until it
pops under the rail and into the boat.
Reattach the seat base in the boat. Make sure you
locate the brass slider that is in the track on the seat
base. Once located, align the tapped hole with the
hole in boat and re-insert the knob (pictured below).
Reinsert the seat one side at a time starting in the
high position (pictured above). Once it is
completely in, drop it in the low position and
reattach all three bungee points.