Nautilus ONE Owners Instructions And Assembly - page 7
Figure 6
Figure 7
Step 4. Remove The Inside Shroud
(Figures 7 and 8)
4-1 Adjust the selector knob to the lowest setting, and
then lift it up and out of the way. Remove the
center cap by carefully pressing it out of the tabs
in the shroud opening;
4-2 Lift the inside shroud up until the tabs stop at the
top of the P-slots;
Note: do not attempt to remove the shroud by prying
with any type of tool or the tabs may break off!
Tower Shroud And Cover Installation
After the seat frame has been installed, follow these
instructions to re-install the weight tower shrouds and
top cover.
Step 1. Re-install The Inside Shroud
(Figures 5 and 7)
1-1 Position the inside shroud against the frame so
that the tabs align with the P-slots;
1-2 Carefully insert both the front and back tabs into
the P-slots;
1-3 Push down on the tabs until they are seated at the
bottom of the P-slots;
Note: when the tabs are properly aligned in the P-slots,
the shroud should drop down into the slots with minimal
resistance. Take care not to force the shroud downward
or the tabs may break off!
1-4 Adjust the selector knob to the lowest setting, and
then lift it up and out of the way. Position the center
cap against the shroud so that the openings and
tabs align. Press firmly to secure the cap to the
shroud.
4-3 Carefully pull the shroud out to remove the tabs
from the P-slots.
Figure 5
assembly questions? call 800-235-2233 for help.
7