Nav TV AUDI DYNAMIC-A3 Installation Manual - page 3
BHM
02/14/17
NTV-DOC244
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Installation (A3)
1. With European radio keys, remove the MMI located in glove box. Disconnect any
associated harnesses and set the radio aside.
2. Grab the provided ‘Power/CAN Harness’ from the
DYNAMIC A3 kit. Connect the following wires to the car:
3. Locate the factory Pink (For AUDI’s with
NAV, this connector is GRAY),4-pin round
connector that was removed from the
radio in step 1. Connect this factory plug to
the A3 interface at the port labeled ‘VIDEO
OUT’.*
4. Connect the smaller white
plug side of the provided
LVDS Video Cable to the
port on the A3 interface
labeled ‘VIDEO-IN’.
Interface wires
Connect to car
Location
Black (Ground)
Chassis Ground
PIN 15 (Radio plug)
Red (ACC 12v)
ACC 12v (+)
Black/White @ pass fuse box
Green (Rev 12v in)*
Reverse Lamp (+)
---
*NOTE: You may need to shave
some keyways on the factory
connector in order for it to fit
into the VIDEO-OUT connector.
*Note: this Green wire is ONLY used if CAN
connection does not switch display to
reverse image while in reverse properly.