Nav TV AUDI DYNAMIC-A3 Installation Manual - page 8
BHM
02/14/17
NTV-DOC244
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
8 |
P a g e
Adding HD-LINK Adapter (HDMI Input)
Follow the instructions below when adding the HDMI adapter (HD-LINK) to enable HDMI
input to the OEM screen:
1. Put dip switch #1 in the DOWN
position.
2. Activate the ‘NAV INPUT’ by
pressing the ‘NAV’ button on the
dash.
3. Once ‘NAV INPUT’ shows on the
screen, on the remote press the
OK BUTTON 4 times, then press
POWER.
4. Navigate to the ‘NAVI’ section.
a. Select ‘HDMI-SEL’
b. Choose ‘HD95E’
c. Press MODE on the remote to
return and exit the OSD menu (or let it time out).
5. Replace dip switch #1 to the UP position.
6. Connect the black wire to ground (-) and the red wire to ACC power (+) from the main
power connector on the HD-LINK adapter. The RCA’s on this plug provide audio from the
HDMI source.