Nav TV NTX-54 Installation Instructions Manual - 4.3” Monitor
12 |
P a g e
Completing the Setup Procedure: VERY IMPORTANT!!!!
After you have setup the rear view camera, navigation and verified that the software in the UCI is current you
will be back at the main screen. This screen shows UCI by NAV-TV, Camera input settings, navigation input
setting, video in motion and about. Below the "about" is the word "exit". In order to store all your setting you
MUST press this exit button. If you switch modes during this process, turn off the vehicle or disconnect any
cable the settings will not be saved and you will have to start from step 1 again.
Put the vehicle to sleep by closing ALL doors, the hood and trunk and locking the car with the key fob or key
and wait 5 minutes.
After 5 minutes unlock the vehicle and check the system. For operation please refer to page 12 "reverse and
navigation operation"
Operation
Rear View Camera
The rear view surroundings will be displayed anytime the vehicle is shifted into REVERSE. The image will be
displayed on the factory touch screen along with the text “Check Entire Surroundings”. The text will remain on the
screen for 10 seconds and then will fade out. Once the vehicle is shifted out of REVERSE, the image will fade into the
previous mode or screen. Do not rely completely on the rear camera image; periodically check your surroundings for
obstacles.
Navigation
4.3” monitor
To display navigation, press the “Screen Off” button. This will display the navigation home page. To exit
navigation press the Screen Off button again. Audio prompts will be heard through the external speaker. Refer to the
navigation documentation for operation.
8.4” monitor
When navigation is enabled, a new icon will show up in the bottom right corner of the screen, where the “More”
soft key is located. This icon may take up to 10 seconds to appear once the vehicle has been unlocked. To access the
navigation, press the “Nav” soft button on the lower right corner. The navigation screen will be displayed. All the
functions of the navigation can be controlled through the factory touch screen. (Refer to the user manual for operation).
To exit the navigation screen, press the desired source. The “More” soft touch button for the factory SETTINGS screen
can be accessed through the navigation screen. While in navigation mode, if the climate control is adjusted the
navigation screen will disappear anytime the system is being accessed. 3 seconds after the last operation, the navigation
screen will return.