Nav TV StreamBlue NTV-KIT510 User Manual - Rcas
BHM
10/09/14
NTV-DOC190
rB7
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
4. Unplug power to the SteerBlue module. On the side of the StreamBlue module, select the audio
output type being used* After the audio output format has been selected via the dip switch plug
power back into the SteerBlue module:
Dip Switch
1
2
X
X
Dip Switch
1
2
X
X
5. Once all the above steps are completed, test for proper functionality by enabling the Bluetooth
function on your smart-device. With the car on, do a scan for devices and ‘StreamBlue’ should
display. Select ‘StreamBlue’ and allow your Tablet or Smartphone to connect to it. Paired
devices will be remembered. There is no programming necessary for the StreamBlue.
6. Once installation is complete, it’s a good idea to cycle the ignition a few times to emulate exiting
and re-entering the vehicle and check for auto-reconnect functionality. Give the StreamBlue up
to one minute to reconnect with a smart device after cycling the ignition.
7. Optional: Output 1 (Blue) provides 12v+ output when Bluetooth is active (linked with a smart-
device). This wire is limited to a 1 Amp output and is perfect for use as an amplifier turn on. If
not using this wire, insulate for protection.
8. The Brown, Brown/Red and White/Red wires on the StreamBlue harness are not used
presently and are for future use. Please insulate the end of these wires.
RCAs
S/PDIF
*Only one type of audio output
can be used at a time: analog
or digital.
* Audio output selection is made when the module is unplugged. Volume control is not supported when S/PDIF is used.