Nav TV StreamBlue NTV-KIT510 User Manual - page 7
BHM
10/09/14
NTV-DOC190
rB7
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
7 |
P a g e
StreamBlue Operation
The StreamBlue will remember up to 8 different devices. After 8 devices have been connected, it
will delete the oldest device on the list automatically.
Using the StreamBlue in conjunction with a factory radio is not supported at this time. This is a
limitation caused by the third party steering wheel control interface due to the fact that they
were engineered to be used ONLY when replacing the factory radio, not in combination with
the factory radio.
General functionality of the StreamBlue will vary due to differences in hardware platforms and
operating systems. NAV-TV cannot support every claimed feature for every device.
VOICE COMMAND usage on Android will play audio over BT, alternate devices will not (audio
will be heard from the device, not over BT)
Once accessory is present on the red accessory wire of the StreamBlue it will automatically look
for the last device that was active. E.G. if an in dash tablet was last used with the device and
functioning when the vehicle was turned off, the StreamBlue will first attempt to connect to this
device when the ignition is turned on again.
While in use, the StreamBlue will stay connected to the paired device in use unless:
o ACC power (red wire) is removed,
o Bluetooth is turned off on the connected device,
o The StreamBlue device is deleted from the connected device, or
o The connected user’s device falls out of range (~15-20’) to the StreamBlue*
Volume control (from steering wheel) controls the StreamBlue exclusively (no indication on
Android, other devices will show volume bar), so it’s best to set the smart device’s volume to
desired standard volume level. NOTE: Volume control is not supported for S/PDIF out
applications. If Volume is adjusted from the smart device, it will control the volume of the
StreamBlue when connected and paired.
The StreamBlue will wake up the smart device if in sleep mode automatically upon Bluetooth
connection. (It will not unlock the device if locked)
To begin music playback on smart devices after Bluetooth connection, simply press the button
assigned to the SOURCE/MODE command once. This button may have to be pressed twice for
this command.
Pressing and HOLDING (3 seconds) the SOURCE/MODE button will disconnect (Bluetooth) the
last paired device. This command only disconnects, it will not connect a device.
On Android devices it may be necessary to open the music player or APP upon wakeup before
the device can be controlled by the StreamBlue (device dependent, many Androids will begin
playing the default music player). This varies with many devices and your individual device must
be tested after installation to see if "AUTOPLAY" is supported with your Android device.
*Note: if the connected device falls out of range and returns (assuming the StreamBlue is still on and
running), the StreamBlue may have to be manually reconnected on some devices.