Navig8r NAVSPORT1080 User Manual - Charging The Battery
6
CHARGING THE BATTERY
Turn the camera off and connect the USB cable to the camera and to your power source (i.e. in-car charger,
PC USB port or USB Mains Power Adaptor) The charging indicator light will turn RED. When the battery
charge is full, the light will turn BLUE. A typical full charge takes up to 4 hours.
WATERPROOF CASE
1. Use your fingertip to gently pull the release clamp (4) out and back, in the direction of the arrow (on the clamp)
2. Inspect the white rubber water seal gasket to ensure it is in good condition, and then insert the camera in the
correct orientation.
Note 1: You can test the gasket by closing the case without the camera inside and submersing it completely in a
bowl of water for a few minutes. Remove the case from the water, dry off the exterior with a towel, and then
open the case carefully. If the interior is dry, the camera and case will be safe for use under water.
Note 2: Only two buttons are required for recording video and images: the Shutter Button, and the On/Off
button.
Note 3: Remember, when the unit is turned OFF and ON again, the unit will default to VIDEO modes and
the default resolutions.
On/Off Button
Release clamp
Case Hinge
Shutter Button
OR