Navigon 20 easy User Manual - 7.4

User's manual NAVIGON 20 EASY | 20 PLUS 

- 50 - 

Working with the map 

7.3.1 Configuring 

the proximity sensor 

You can configure the response characteristic of the proximity sensor. 

► 

In the N

AVIGATION

 window tap on Options > Settings > General > 

Motion Sensor. 

► 

Select the responsivity level with which you want the proximity 

sensor to respond to movements (Low Responsivity, Mid 

Responsivity, High Responsivity) 

► 

Select Do Not Use if you do not want to use the proximity sensor. 

7.4 

Map in Standard mode 

The map is always in Standard mode when you are not navigating, 

have not calculated a route and are not searching for a destination on 

the map. 

Under the following circumstances the map switches automatically to 

Standard mode: 

► 

You begin a trip while the N

AVIGATION

 window is open. The switch 

takes place after only a short while. 

► 

You reach the destination of a navigation in Vehicle mode. 

To open the map: 

► 

In the N

AVIGATION

 window tap on Show Map. 

Note: If GPS reception is not good enough to establish your location, the 

map will be opened in Destination search mode. 

The following features are typical for this view: 

► 

Indicated in the middle of the lower third is your current position 

(orange arrow). The map view follows your movements so that your 

position is always visible on the screen.