Navigon 2100 User Manual - 9.2

User’s Manual NAVIGON 2100 | 2110 max 

Troubleshooting 

- 53 -  

9.2 

Identification and serial number 

The navigation system has various identification labels under the rear 

cover. (e.g. CE label, serial number, ...) 

If you need to see any of these labels, proceed as follows: 

1.  Switch off the navigation device. 

2.  Take the memory card out of the device. 

3.  With your thumbnail in the slot on the bottom of the device, pull the 

rear cover off the device. 

To close the rear cover again: 

1.  Place the cover correctly back in position. 

2.  Push the cover firmly against the device until it latches home in all 

corners. 

3.  Re-insert the memory card. 

Note: We recommend that you remove the rear cover only when told to 

do so by our service staff. 

9.3 

Declaration of conformity 

The NAVIGON 2100 | 2110 max described in this manual bears the CE 

label among others. 

Products with the CE marking comply with Radio & Telecommunication 

Terminal Equipment Directive (R&TTE) (1999/5/ECC), the 

Electromagnetic Compatibility Directive (89/336/ECC) and the Low 

Voltage Directive (73/23/ECC) – as amended by Directive 93/68/ECC – 

issued by the European Community Commission. 

Compliance with these directives implies conformity with the following 

European Standards: 

EN301489-1, EN301489-3, EN50332-2, EN55022, EN55024, 

EN61000-3-2, EN61000-3-3, EN60950 / IEC 60950, 

EN301357-2 V1.3.1 

The manufacturer is not liable for modifications made by the user which 

may alter the device's conformity with the CE label, nor for the 

consequences thereof. 

10 Troubleshooting 

In this chapter you will find solutions to problems which may arise 

during use of the NAVIGON 2100 | 2110 max.