Navison Audio NVS - 211SE Setup And Operation Manual - Installation
Installation
This section describes the unpacking and installation procedures for your new amplifier.
Unpacking
All shipping containers have been specially designed to protect their contents and special care
has been taken to prevent damage under normal shipping conditions. Mishandling should be
evident upon inspection of the shipping container. If shipping damage is found after visual
inspection, take care not to destroy the evidence. If necessary, document the damage with
photographs and contact the transport carrier immediately.
Carefully remove your new NVS-211SE from its packing carton and examine it closely for signs
of shipping damage. It is recommended to save all original packing cartons and crates to protect
your amplifier from damage should you wish to store it or ship it for after - sales service.
Physical Placement
The NVS-211SE is designed for use in homes. It must be protected from the elements and
temperature extremes. For example, avoid placing the unit in extremely hot locations such as
near radiators or other heating units. Its location among the user’s audio components is not
critical; however, certain precautions must be taken. Avoid moisture, direct sunlight,
and dusty areas.
Power Requirements
The NVS-211SE is designed to operate from house current AC mains. The design voltage is 115
Volts AC at 50/60Hz (Export units 230 Volts AC at 50/60Hz, by market).
NVS-211SE Owner’s Manual
3