Navitar Presenter User Manual - page 12
12
Installation
Installation
To install the Presenter, proceed as follows:
Before starting, review the precautions on page 7.
1. Loosen the camera head lock downs, move them to
the extreme limit, then tighten back down.
2. Plug in the power cable.
3. Connect the cable to your peripheral equipment (TV
monitor, video projector, etc.). The connection for
Composite Video, Component Video or RBG/Sync is
BNC and a 4-pin MiniDin forY/C (S-Video).
4. If genlocking, connect the external sync cable to the
external sync input port of the projector. Skip to
number 6 if you are not using genlock.
5. If genlocking, follow the complete procedure on page
21.
6. On the menu control panel, set the projector/camera
menu control switch to the projector position. Make
sure that the green LED is lit. (If the yellow LED is lit,
only the menu panel controls will work.)
7. Place your document, object or X-ray on the viewing
surface and “power-up” all equipment.
8. Press the home position button on the Presenter to
center the image on your screen.
9. When the unit is powered-up, the factory settings for
focus and iris are in the auto gain and auto white
balance modes. See the camera set-up section for
optional settings procedure.
10.Press the zoom button to select the correct picture
size for your presentation.
11. Adjust the TV monitor/video projector controls for
contrast, brightness, etc. Then adjust the zoom, iris
and focus controls on the main control panel of the
Presenter to produce a suitable image size, focus and
brightness. (Adjust the base illumination system if
required.)