Navitar VideoMate 2300 User Manual - page 7
6
Safety Precautions
Warning
To prevent damage to the equipment and operating
personnel, please observe the following precautions:
Use the correct voltage source as specified on the
label.
Make sure that the voltage source contains a satisfac-
tory path to ground.
Do not operate the unit where fluids can come into
contact with the electrical components.
Maintain a six inch air space around all sides of the
equipment to allow for proper ventilation.
When changing the bulb:
1.
Disconnect the electrical supply.
2.
Allow the unit to cool.
3.
Use only ESJ or ESH lamps or the equivalent
(82 volt, 85 watt). Higher wattage lamps will
cause severe internal damage to the camera and
electronics.
There are no user serviceable components (other than
changing the lamp). Opening the unit will expose
dangerous voltage levels and sensitive electronic
components. A qualified technician should perform all
repairs.
To protect the unit from damaging condensation and
thermal shock, certain procedures must be followed.
1.
In cold weather, always put the unit in a moisture
proof container or enclosure before transporting.
2.
Either keep the unit warm during transportation, or
allow sufficient time for it to warm up at the
destination. Keep the unit in the original moisture
proof package while it warms up. (The goal is to
prevent warm, moist air from striking the cold
electronic and optical components, which will
cause damaging condensation).
Never operate a cold projector to warm it up.
Safety
Precautions