Navitel E100 User Manual - page 39
Using device - navitel e100
| 39
EN
case are prohibited as it may result in the device working
incorrectly and in extreme cases can cause damage. Any
alterations to the device must be carried out by qualified
personnel.
13. The device takes its power from the built-in Li-Pol battery,
which can explode or release toxic substances if exploited in
an inappropriate way. Do not subject the device to physical
impact nor use it close to explosive liquids or gases.
14. Ensure normal ventilation conditions for the power adapter
during charging since a lot of heat is released in the process.
Do not cover the adapter with paper or other objects that may
worsen ventilation.
15. Do not apply too much force when cleaning the display and
other parts of the device. Do not use paper napkin or any hard
material that can scratch the device for cleaning. Use soft cloth
only.
Using Device in Vehicle
Windscreen holder and battery charger are delivered as part of
the product package.
Windscreen holder
ATTENTION! Carefully select a place to attach the holder. Do
not attach the holder to the windscreen in a way that limits the
driver’s line of sight. If the car windscreen contains a built-in
heating system or UV protection, the quality of signal reception
may be lower than usual.
Set-up of windscreen holder
First remove the protective layer from the vacuum cup. Then,
select an appropriate place to attach the holder. Make sure
the area is clear of dust, dirt, and moisture, and then secure
the vacuum cup on the windscreen. Under normal operating
conditions, the vacuum cup holder locks the device well.
However, if you leave it there overnight, the holding strength
may get weaker as a result of moisture condensation due to
temperature fall. For this reason, in order to prevent the device
and holder from being damaged, it is recommended to remove
the device and holder from the windscreen.