Navman SPEED 2100 Installation And Operation Manual - 2 Instrument Setup
5
SPEED 2100 Installation and Operation Manual
N AVM AN
Trip Log Reset
Select the TRIP LOG mode. Press and hold the
key until the display resets to zero.
Press and hold
Information will now be indicated in the selected
display unit.
Calibrating SPEED Against a Known
Reference
1. Select SPEED mode
2. Press and hold the
and
keys for 5
seconds.
3. Release both keys when the display shows the
following:
CAL
4. While travelling at the known speed , press the
key to increase the displayed speed or the
key to decrease the reading.
5. When the correct reading is indicated, press
and hold the
and
keys again for two
seconds.
6. Release both keys when the display shows the
following:
SPd
Calibrating DISTANCE Against a
Known Reference
1. Select the TRIP LOG mode.
2. Press and hold the
and
keys for 5
seconds.
The instrument must be calibrated after installation
to ensure accurate speed readings.
Selecting units of measure
The SPEED 2100 will indicate boat speed in Knots
(nautical miles), MPH (statute miles) or KPH
(kilometres). To change the current setting perform
the following steps:
1. Power up the unit while holding down the
key.
Hold down during power up
2. When the unit is on, release the
key. The
display will indicate the current display unit with:
Knots (nautical miles)
MPH (statute miles)
KPH (kilometres)
3. To select the display unit desired, use the
and
keys to change the value.
4. To exit this mode, press and hold both the
and
keys simultaneously for one second.
Press and hold to exit
Total Log Reset
Press and hold the
and / keys while powering
up and hold for at least 30 seconds until the
TOTAL LOG is reset.
Press for 30 seconds