Navman SPEED 2100 Installation And Operation Manual - page 8
Manual is about: Navman Speedometer
of
12
SPEED 2100 Installation and Operation Manual
N AVM AN
8
Wiring Connection
•
Keep electrical and transducer cables away
from alternator or other noise generating
electrical cables. Avoid connecting the
instrument to power circuits that share loads
with ignition, alternators, inverters and radio
transmitters. Electrical power supply
connections should always be as short as
possible.
•
Connect the red wire to the positive supply via
a 1 amp fuse or a 1 amp circuit breaker.
Connect the black wire to the electrical ground.
•
Connect the 4 pin Fuji connector to the speed
and temperature transducer cable connector.
Extension cables are available if the
transducer cable is too short.
600mm (24”)
POWER CORD
BRACKET
BUZZER
RED
(+) TERMINAL
BLACK
(-) TERMINAL
4 PIN
CONNECTOR