NavTour G4 Quick Start Manual - page 17
Additional Info
CE Compliance & FCC Compliance
This product, together with its original accessories, has been built in compliance with relevant EMC and safety
regulations. However, there is no guarantee that the usage of the product will still comply with the EMC standards
when third-party accessories or cables are used. Users who use third-party accessories or cables shall assume
full responsibility in ensuring that the product (along with its accessories and cables) will comply with all relevant
standards and requirements. To avoid common EMC issues, users are advised to:
‧
Use only accessories bearing the CE marking in conjunction with the product.
‧
Use properly shielded signal cables.
This device has been tested and found to comply with the limits of Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this device does cause interference to radio
or television reception, which can be determined by turning the device off and on, the user is encouraged to try to
correct the interference by one or more of the following measures
‧
Increase the separation distance between the device and receiver.
‧
Connect the device into an outlet on a circuit different from that to which the receiver is connected.
‧
Consult the dealer or an experienced radio/television technician for help.
‧
Reorient or relocate the receiving antenna.
Only electronic equipment certified to comply with the FCC Class B limits may be used for the product. Using non-
compliant peripherals or non-certified accessories may result in harmful interference to radio communication.
When connecting to an external device or a PC via its USB port, use only properly shielded cables. Changes or
modification not expressly approved by the manufacturer could void the user’s authority to operate the device. This
device complies with Part 15 of the FCC Rules, and operations conform to the following standards.
‧
This device may not cause harmful interference.
‧
This device must accept any interference received, including interference that may cause undesired operation.
16