Naxa NAS-3074 Instruction Manual - page 13
www.naxa.com
Page 13
Troubleshooting Guide
This guide lists common problems and their solutions.
Please refer to this guide before requesting service.
If you need further assistance, please contact Naxa
Technical Support (www.naxa.com/naxa_support/).
Symptom
Possible Cause
Possible Solution
There is no
power.
The battery is
exhausted.
Connect the unit to a
USB power source to
charge it.
The speaker hasn’t
been turned on.
Set the Power switch on
the back of the speaker
to the “ON” position.
The device
is unable to
connect to the
speaker.
The speaker is not
in pairing mode.
Reset the speaker (turn
it off and then set the
Power switch to the
“ON” position.
Bluetooth may be
disabled on the
device.
Make sure Bluetooth is
enabled on your device.
Turn it on if it isn’t.
Symptom
Possible Cause
Possible Solution
The device is
connected but
there is no
sound.
The AUX connector
may be in use.
Disconnect all cables
from the AUX in-
put connector of the
speaker.
The speaker may be
in the wrong mode.
Press and hold /M to
change the active mode.
Your device may be
beyond the effec-
tive range of the
speaker.
Move closer to the
speaker. Range may
be affected adversely
by environmental
conditions.
Your device may
not be in playback
mode.
Ensure that your device
is operating correctly.
Start playback on your
device.