Naxa NAS-3074 Instruction Manual - page 9
Manual is about: portable bluetooth
of
16
www.naxa.com
Page 9
Using the AUX Input
Connector
Connect devices without Bluetooth
®
by using the in-
cluded combination USB + 3.5mm AUX audio cable.
Connect the 3.5mm plug of the combination cable to
the device’s headphone or line-out jack; connect the
other end to the DC5V/AUX/FM connector [2] of the
speaker. Set the Power switch [1] to the “ON” position,
then press and hold /M [7] to set the speaker mode
to AUX.
1. Press and hold –/ [7] to lower the volume on the
speaker.
2. Set the volume of the device to 80% of its maxi-
mum.
3. Start playback, then press and hold /+ [9] to
gradually increase the volume of the speaker to a
comfortable level.