Naxa NAS-3076 Instruction Manual - page 8
Page 8
Naxa Electronics
⚠
L
You may also use your device to control
playback. Some devices may not support
remote Bluetooth® controls.
Bluetooth
®
Phone Controls
When the speaker is connected to a Bluetooth
®
device:
To do this...
...do this
Answer an incoming call
Press
Reject an incoming call
Press and hold
End the current call
Press
Redial the last number
Press
twice quickly.
Using the AUX Input
Connector
Connect devices without Bluetooth® by using the AUX
connection. A 3.5mm stereo patch cable is required to
make this connection.
1. Use the included AUX cable to connect the device’s
headphone or line-out jack to the AUX connector
[1] found on the side of the speaker.
2. Turn on the device and the speaker. Lower the vol-
ume on both.
3. Set the device volume to 80% of its maximum and
then start playback.
4. Press and hold + [6] to increase the volume gradu-
ally to a comfortable level.
⚠
L
Use the connected AUX device to control
all functions in AUX mode. The speaker can
only be used to adjust the volume.
When the speaker detects an AUX cable, it will auto-
matically switch away from Bluetooth mode.