Naxa NAT-500 Instruction Manual - page 15
www.naxa.com
Page 15
Troubleshooting Guide
This guide lists common problems and their solutions. Please refer to this guide before requesting service. If you
need further assistance, please contact Naxa Technical Support (www.naxa.com/naxa_support/).
Symptom
Possible Cause
Possible Solution
There is no
power.
The battery is
exhausted.
Connect the unit to a
power source to charge it.
The speaker hasn’t
been turned on.
Set the Power switch to ON
to turn the speaker on.
The handset hasn’t
been turned on.
Press and hold
[21] to
turn the handset on.
The device
is unable to
connect to the
speaker.
The speaker is not in
pairing mode.
Reset the speaker (turn
it off and then on again.)
Switch to Bluetooth mode.
The Status LED [16] will
flash blue to indicate that
it is ready to pair.
Bluetooth may be
disabled on your
device.
Make sure Bluetooth is
enabled on your device.
Turn it on if it isn’t.
Symptom
Possible Cause
Possible Solution
The device is
connected but
there is no
sound.
The AUX connector
may be in use.
Disconnect all cables from
the AUX jack [10].
Your device may be
beyond the effective
range of the speaker.
Move closer to the speaker.
Range may be affected
adversely by environmen-
tal conditions.
Your device may not
be in playback mode.
Ensure that your device is
operating correctly. Start
playback on your device.