Naxa NAT-500 Instruction Manual - page 8
Page 8
Naxa Electronics
Charging a USB Device
When the speaker base is connected to power, you can
use it to charge another USB device such as a mobile
phone. Instead of using your mobile phone at home,
leave it charging and use the NAT-500 speakerphone/
handset instead!
To charge your phone or other USB device:
1. Using the USB cable that was included with your
phone or device, connect the large end to the USB/
Charge port of the speakerphone [11].
2. Connect the smaller end to your USB device.
L
L
The USB/Charge port power output is DC
5 V, 1 A. Devices with larger screens may
require more current and take longer to
charge.
Using Bluetooth
®
Mode
Pairing a Device with Bluetooth
®
A device must be paired with the speakerphone before
using them together for the first time.
Make sure Bluetooth is enabled on your device before
attempting to pair it.
Set your speakerphone to Bluetooth mode (press and
hold
until the Mode LED [15] is blue). The speaker-
phone will automatically search for a paired device. If it
finds a paired device, it will connect to it automatically.
If it does not detect a paired device, it will switch to
Pairing mode (the Status LED [16] will flash blue). When
the speakerphone is in Pairing Mode, it will announce
itself to nearby Bluetooth devices and accept pairing
requests from them.
1. The speakerphone will announce itself as the
NAXA
NAT-500
. To find it, use your device to search for
nearby Bluetooth devices. (This function is usually
in the Bluetooth settings menu; refer to your de-