Naxa NHS-2006 Instruction Manual - page 10

Page 10 

Naxa Electronics

Using the Remote Control

Before  using  the  remote  for  the  first 

time, remove and discard the plastic 

insulation tab as shown.

Aim the remote control at the front of the sound bar 

and then press a key. 

⚠

L

Obstacles between the unit and transmit-

ter may prevent the remote control from 

working. Direct sunlight, incandescent or 

fluorescent lamps, or any other strong 

light shining on the remote sensor of the 

unit may prevent the remote control from 

working properly.

Replacing the Battery

The remote control is powered by one (1) 

“CR2025”-type battery.

1.  Squeeze the tab of the battery com-

partment to the right while drawing 

the battery tray out.

2.  Take note of the orientation of the 

existing battery. Replace it with a new 

“CR2025” lithium battery, making 

sure to match the polarity of the old 

battery (as well as the +/- markings 

on the remote control.

3.  Push the tray back into place.

⚠

L

The battery in the remote will last for ap-

proximately 1 year. Replace the battery if 

the remote control does not work. Always 

dispose of batteries according to your local 

municipal regulations. 

⚠

⚠

The batteries used in the remote control 

may present a fire or chemical burn if 

mistreated. Do not recharge, disassemble,