Naxa NHS-2006 Instruction Manual - page 5
www.naxa.com
Page 5
Naxa Electronics recommends that wall mounting be
performed by a qualified professional installer. Naxa
is not liable for any accidents or damage to property
or the sound bar due to incorrect installation.
1. Using a level and ruler, use a pencil to mark 2 points
on the wall that are 22.13 inches apart. Use the level
to ensure that the points are on the same horizon-
tal plane and are parallel to the ground.
22.13 inches
2. For drywall installations only; for wood, skip to
step 3: Use the drill with a 7/32” bit to drill a hole at
the two marked points on the wall. Using a hammer,
gently insert the drywall plugs in each of the holes.
The plugs should fit completely into the hole, with
the tops of the plug flush with the wall.
(For installations in brick or concrete walls, please
obtain a masonry bit, plugs, and screws from your
local hardware store.)
3. Use a screwdriver to drive the screws partially
into the wall at the two marked points. Allow the
screws to extend 0.3 inches from the wall.
22.13 inches
1. Screws
2. Drywall plugs
(optional)