Naxa NRC-180 Instruction Manual - page 13
www.naxa.com
Page 13
Using AUX Input
Connect devices without Bluetooth
®
by using the
AUX connection. A 3.5mm AUX cable is required to
make this connection.
AUX input only works when the system is in FM
radio mode and a 3.5mm AUX cable is plugged in.
1.
Press the
button until the dis-
play screen shows the FM radio frequency.
2. Use the 3.5mm plug of the included AUX cable
to connect the device’s headphone or line-out
jack to the AUX connector of the system.
3. Turn on the device and the system. Lower the
volume on both.
4. Set the device volume to 80% of its maximum
and then start playback.
5. Press VOL–/AL1-SET to gradually increase the
volume of the speaker to a comfortable level.
ѥ
L
Use the connected AUX device to
control all functions in AUX mode.
The speaker can only be used to
adjust the volume.
Charging Your Devices
Connect the standard end of a USB cable (not in-
cluded) to the USB port on the rear of the unit and
connect the other end to the charging port of your
device. USB cables may differ by manufacturer, so
be sure to use the one provided with your device.
ѥ
L
Some devices may not support USB
charging or may require a higher
power rating than this product
provides. Observe the charging
status on your device, or refer to
the manufacturer’s specifications.
There are many different devices
with different power requirements;