NCE Mini-Panel Manual - page 8
you get to step 2 do not enter the second accessory command, instead select the
DELAY command.
To access delay commands:
Press “ENTER” at the following prompt to see more command options:
INP: 03 STEP: 2
1=ACCY 2=MACRO
You will see more commands.
INP: 01 STEP: 2
3=LOCO 4=SIGNAL
Press “ENTER” again to see the “OTHER CMDS” Prompt.
INP: 01 STEP: 2
5=OTHER CMDS
Press ”5” to be presented with “OTHER” commands that are available
SELECT CMD GROUP
1=DELAYS 2=WAIT
Press “1” to use the DELAY command.
SELECT INTERVAL
1=4SEC 2=1/4SEC
We want a 1 second delay. The 4 second interval will be too long so press “2” to
select the ¼ second interval delay command.
SELECT CMD GROUP
NUM 1/4 SEC: 00
Press “4” followed by “ENTER” to introduce a 1 second delay (4 x ¼ = 1).
INP: 03 STEP: 3
1=ACCY 2=MACRO
Note that the step number is now 3. The delay command uses up one command step.
Proceed to program the second accessory command as normal. When input 3 is
grounded the first accessory command will be sent immediately. After a 1 second
delay the second accessory command will be sent.
NOTE: The Mini Panel will do nothing while it is performing a delay. If you use a very
long delay activity on other inputs may be missed. With the short delays
Last revised: 9 December 2008 Page 8