NCE NCECD100W Instruction Manual - page 7
GENERAL OPERATIONS
GENERAL OPERATIONS
Power ON/OFF
Press any button to turn the unit on. Press and hold POWER button to turn off the
unit.
Note:
After the unit is off, the volume level and radio current settings will be
memorized, and when you turn the unit on it will resume the stored
status, which you set.
FRONT PANEL RELEASE
Press REL button (2) to detach the removable front panel
SOUND ADJUSTMENT
Turn on (3) can adjust the desired volume quality.
A).Press SEL button (3)
will change in the following order.
Option:
Volume control/select
Rotating this knob, you can adjust VOL/BASS/TREB/BAL/FAD . To select the
functions, press the VOL knob shortly until the desired functions are shown on the
display.
Increase or decrease the volume by turn the VOL knob right or left. These buttons
can be used to adjust the BASS, TREBLE, BALANCE and FADER.
VOL
BAS
TRE
BAL
FAD
(
Volume
)
(
Bass
)
(
Treble
)
(
Balance
)
(
Fader
)
BASS
Press VOL/SEL button(3) one time. Adjust bass level by using VOL/SEL(3)Knob.
TREBLE
Press VOL/SEL button(3) two times. Adjust treble level by using VOL/SEL(3)
Knob
BALANCE
Press VOL/SEL button(3) three times. Adjust sound balance between left and
right speakers by using VOL/SEL(3)Knob.
17
06
REMOTE CONTROL LAYOUT
Replacing the Battery
When
the
operational
range
of
the
remote
control
becomes
short
or
non
functions
while
operating
.
Replace with a
new
CR2025
battery
.
Make
sure of
the
battery
polarity
before
replacement
.
1
.
Pull
out
Battery
Holder
while
pressing
the
stopper
2
.
Put
the
button
type
battery with the
(+)
mark facing upward
into
the
Battery
Holder
.
3
.
Insert
the
Battery
Holder
into
the
Remote
control
6. How to delete stored phone number?
The unit can store ten numbers of missed ,rejected and ANS separately,
and the first number will automatically be deleted when the 11th number calls.
7. How to use “RECEIVED” “MISSED” “REJECTED” “MANU
ANS/AUTO ANS” Functions.
Press “MUTE” for 3 seconds to enter into “RECEIVED” “MISSED” “REJECTED”
“MANU ANS/AUTO ANS”. Turn VOL button for choosing the telephone number.
PLEASE NOTE:
Some incoming phone calls maybe not be able to be answered by
the head unit controls when there is No Caller ID or the incoming phone number is
stored in the phone contacts under more than 1 contact card.