Nclebo AID9812 Instruction Manual - Installation - Dc12V Camera

Installation - DC12V Camera

1    Use the philips screwdriver to remove the screw (D).

2    Separate upper case (A) from bottom case (E).

3    Use philips scrwdriver to loosen screw (I) and remove gimbal (C).

4    Cut a hole  in the ceiling for routing the cables.

5    Align the camera unit with the surface of the ceiling, make marks 

      on the ceiling in the places where the screw holes are to be drilled, 

      and then drill the four holes.

6    Pass the power cable (F) and video cable (G) from the camera unit 

      through the cable hole in the ceiling.

7    Align the four screw holes in the camera unit (E) with the screw 

      holes in the ceiling, and then secure the camera in place by 

      tightening the four or more screws  (B).

8    Fix the gimbal (C) by using screw (I).    

9    Carry out the settings and adjustments for the camera.

10  Adjust the dome liner (H) so that the dome camera's lens is visible 

      from the camera window, and then use a philips screwdriver to fix 

      the dome cover.

11  Connect upper case (A) and bottom case (E) 

12  Tighten the screw (D).

D

A

E

I

B

C

F

G

H

D

A

E

I

B

C

F

G

11