Nclebo AID9812 Instruction Manual - page 13

Installation - AC/DC Dual Camera

1    Use the philips screwdriver to remove the screw (C).

2    Separate upper case (A) from bottom case (D).

3    Cut a hole  in the ceiling for routing the cables.

4    Align the extention ring with the surface of the ceiling, make marks on 

      the ceiling in the places where the screw holes are to be drilled, and 

      then drill the two holes.

6    Pass the power cable (H) and video cable (G) from the camera unit 

      through the cable hole in the ceiling.

7    Align the four screw holes in the camera unit (F) with the screw holes 

      in the ceiling, and then secure the camera in place by tightening the 

      two or more screws  (E).

8    Fixing mounting extention ring(F) on bottom case(D) by using screw(B) 

9    Carry out the settings and adjustments for the camera.

10  Adjust the dome liner (I) so that the dome camera's lens is visible 

      from the camera window, and then use a philips screwdriver to fix the 

      dome cover.

11  Connect upper case (A) and bottom case (D) 

12  Tighten the screw (C).

A

C

F

D

E

H

G

B

I

A

C

F

D

E

H

G

B

12