NDS VIMA User Manual - page 11
VIMA Overview and Installation | 3
VIMA Overview and Installation
Overview
VIMA is a family of three product configurations that enable a clinical user to manage video and image routing,
the recording of videos, and capturing of images. VIMA is used in the Operating Room and Endo/GI procedure
room environment, and it integrates with the hospital electronic medical records (EMR) systems utilizing the
DICOM interface standard.
VIMA, as a stand-alone device, supports multiple digital input and output standards. When used in combination
with ScaleOR, various legacy analog input signals can also be supported. VIMA is controlled from an external
touch screen display via an intuitive graphical user interface.
VIMA Models:
•
VIMA Video Manager with Recorder
•
VIMA Video Recorder
•
VIMA Video Manager
VIMA Installation
•
Place the unit on a flat surface.
•
Stacking of the VIMA device on another device is allowed.
•
Leave a space of at least 5 cm from other devices on the left-side, right-side, and rear of VIMA.
Leave a space of at least 5 cm from other devices on the left-side, right-side, and rear of VIMA,
especially high-frequency surgical equipment.
WARNING: Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
Connection Procedure
1. Connect the video source to video input (HDMI, 3G-SDI, or HDBaseT).
2. Connect the target device to output video signals (HDMI or HDBaseT).
3. Connect the control display to one of the display ports (DP++ or HDMI 1 Touch).
4. Connect the required accessories (touchscreen, keyboard, mouse, etc.) to the USB ports.
5. Connect the power source as indicated below.
Power Supply
The power supply voltage must match the voltage indicated on the label.
•
Connect the power cable into the facility power outlet.
•
Connect the power cable into VIMA receptacle.
•
Connect the potential equalization plug into connection for potential equalization on VIMA.
•
Connect the cable for the potential equalization to the facility.
Connecting Accessories
WARNING: Combinations of accessories that are not listed in the instruction manual may only be used if they are
intended exclusively for a given use and do not affect the performance, safety, and EMC characteristics of VIMA.
WARNING: Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm (12 inches) to any part of the (ME EQUIPMENT or ME SYSTEM),
including cables specified by the manufacturer. Otherwise, degradation of the performance of this equipment
could result.
All devices that are connected to the interface must clearly meet the relevant IEC standard (eg. IEC 60950 devices
for data processing and IEC / EN 60601-1 for medical electrical equipment).
All configurations must comply with the system standard IEC / EN 60601-1.
When connecting devices to each other, ensure that the configuration and system complies with standard IEC /
EN 60601-1 or equivalent national standards.
For assistance, please contact your local distributor or manufacturer.